Custom Database copy

General discussion related to "Everything".
Post Reply
Stretto
Posts: 9
Joined: Mon Sep 28, 2020 5:59 pm

Custom Database copy

Post by Stretto » Tue Oct 20, 2020 11:04 am

I use a 32GB ramdisk. It would be nice if evrything could copy the database to the ramdisk on startup and then copy it back to the original location when shut down. This would speed up things greatly. I noticed my drive thrashes quite a bit when scrolling through the files(it even vibrates my desk).

While I could do this manually it would be better and safer if everything could do it. Simply have another option in the options to update the database to another drive, use it, then copy it back on shutdown if there was an update. [So don't copy if no changes]

Another way to solve this problem is to allow for custom start and end commands that are executed before everything runs and after it runs(with the ability to do it in parallel/async).

froggie
Posts: 172
Joined: Wed Jun 12, 2013 10:43 pm

Re: Custom Database copy

Post by froggie » Tue Oct 20, 2020 5:35 pm

Not necessary. The database is only read at startup (and only written at shutdown) - otherwise it is all in memory.

Post Reply